Noddle
-
Posts
501 -
Joined
-
Last visited
2 Followers
Noddle's Achievements
-
Sold
-
Sold, pending final payment
-
Hi, I'm selling one of my 240K ( 5/'77 ) It's 90% complete, excluding the engine and gearbox ( which i will remove later ) I'm after $6,500 it's in Burnie, Tasmania, email me at noddle at email dot com make sure in the subject you mention "enquiries, Datsun 240K" and don't bother emailing me, if you not serious, or think I will see it for a few thousands only. Nigel
-
The slot for the rotot looks to small ( this maybe for a solid rotor ) Nigel
-
They are actually from a '91 Toyota Surf, ( found my ebay bid )
-
Sorry for the later reply, Calipers are Toyota S13WB ( 4 runner from memory, each caliper had, 4 x 45mm pistons ) Rotors, were special order DBA425USL & DBA425USR ( they did not have the stud holes drilled / blank ) Nigel
-
Find yourself a MR30 skyline, it has a L24e engine in it, swap the head if need be (NM47, or the whole engine), and all the fuel injection bits, I original did this on my 240K, but now I moved onto megasquirt II Nigel
-
No, I was not happy with the resin I used to make the lens with, it deteriorated in the weather. Nigel
-
The early one has Mile Per Hour, and Kilometer Per Hour on the same face, The tachometer are different with how they capture the RPM ( different electronics ) Nigel
-
I see you do not have the earlier speedo..
-
My daughter found this one, 1975 Datsun 240K Sedan | Cars, Vans & Utes | Gumtree Australia Tasmania - Hobart Region make sure you are sitting down, first... :-) Nigel
-
I have one with this colour, with a vinyl roof ( sedan ) Nigel
-
HI, Will this cause clearance issues with wide rims / tires ? Nigel
-
If I was to do it again, I would put the "pickup" inside the fan belt loop the way I did it, I would have to remove the pickup to replace the fan belt, I have not had to do it yet, but i would make it easier .. Nigel
-
Mine was done like this, EDIS Nigel
