siteunseen

Nice! Will you install led bulbs in the gauges? There's some good info here on that. Superbrightleds.com I think is where they get them. It really looks good.

I've got 2.5" on my '72 also. Mine won't fit up into the cut-out on the rear crossmember/differential mount and is a little low. I saw your picture and was amazed. Then I realized it's on ramps. Beautiful car.

@Av8ferg You're wanting a 240. If you haven't already spent a bunch on your efi buy these carbs. You'll have more comfortable 280 with 240 performance. I'll find rossiz'z thread on doing just that. It's a fantastic read with good results as planned. It's on my laptop, sorry but I'm using my phone atm. In my opinion that's the draw to 240s. Those SUs, when dialed in, are awesome. Totally different than efi to me.

$250! With knurled drops. That's a great deal. I wouldn't even sale them.

A good song from the boobies page. Thanks @conedodger

How old is the fuel filter? It does good after cooling? OR the sediment in the filter falls down. I went through that with mine. Ran good for 5 mintues then I walk home to get another car and tool bag. Get back and it fires right up, 5 minutes later "wash rinse and repeat".

Seems like mine show around 13.5 volts while idling. Go to a auto parts store and get a free load test. Check the tension on your alternator belt too. Could be a little loose?

They look nice! It's like a nice shiny front tooth inside a mouthful of coffee stained teeth. ? Now y'all are going to have to do the whole interior. But they do look good.

Okay Boss, I have one headed your way. 3 more to go.

That maybe the ugliest Z I've seen so far but the bar isn't too low. With the values increasing like they are these ridiculous builds are over IMO. No more V8 conversions either thank goodness.

Looks like the bottom half of a floormat to me? There's some canister routing with that rod alongside the valve cover me thinks. Just guessing. The top does look like a section of rebar cut out though. Never seen it stacked like that? There's some heat shield around the injectors too. Somebody buy it and answer our questions, please!

I've learned a lesson today. No more sharing info at a gas station. Just with you guys. "I know nothing!"

You can turn a long one into a short by drilling the pin holes higher. Member Madkaw did it with success. Now I have to drill the 2 front lids that I have left over for a set I'm rebuilding.

@Captain Obvious Right up your alley from what I remember about your bike and those water tubes. @rossiz too. He has some Ducatis.

Nope! All good here. Waiting on cooler weather to put my new valves in a set of float lids. I'll have 4 good lids to swap out and see which valves work best. Hard to take apart a great running car at the moment. Oh yeah, mine had glass balls too! I think that's better from what I've read. Thanks again!!!

Cleaned up a little

What's this from?

Pm your address and I'll get it on the way tomorrow. You want the chrome looking thing too? Might as well send both.

Yep. Only one but it's yours.

I have one. My small stuff box stuff...

That SEM rust inhibitor works good but it turns blackish after applying.

I'll look today. Let you know asap.

Way off, $5,000. Told me where they could buy one for a few thousand. "Here's my phone, call them and I'll buy it today". Then didn't know was it a 2.4, 2.8, Z or ZX. Oh yeah also said no way was the paint original. That's when I quit being polite. its too hot to argue with rednecks.