Hello everyone,

I have two Series-1 hazard switches, and on both, the rocker inside the hazard switch (photo attached of a good one, from google) appears to have snapped, rendering both switches useless. Not sure how common this is, but they both failed around the same time. 

Are we at a point in 2016 where someone can 3D print this bad boy? If not, does anyone have spares, or lastly, know anyone who can rebuild these?

Cheers and thanks.

Bill 

I hand fabricate these out of Delrin plastic.

Contact me at dhp123166@yahoo.com for details.

 

Thanks,

Daniel P.