just installed new flywheel,clutch,pressure plate, release bearing,

When i let up the cluch im getting a bouncing and tremble in the car,like it viberates instead of a smooth shift, anybody know why this is happening?

Sounds like it's either out of align or the pressure plate wasn't torqued properly. Just a guess. Did you use an alignment tool when you put it together?

Did you take care to make sure all the friction surfaces were perfectly clean? A little oil in the wrong place will cause the symptoms you describe.

Steve

No oil on anything I used rubber gloves and yes i used an alignment tool . I had the same problem before i changed anything. Just wondering if the bushing in the transmission support could cause this seeing they are 32 years old. Feels like a bad viberation.