batcave

Colorado. Sry, I'll get that fixed... If anyone has one, I will pay for shipping!

I was replacing the clutch slave cylinder on my 1971 240Z, and I threw out the old one. When I got the new one, I found out that it didn't include the rod that goes between it and the clutch fork! I called around to some places and went to some junk yards, but I just can't find one any where! Does anyone know where I can find this rod? I don't care if it is new or used. I just need it! Thanks!

Thanks for the clarification. Hopefully there isn't too much difference between the '71 and 73' transmissions. Oh, and be careful with those motor mounts! How on earth did you break those?!?!?

Thanks for the reply US240Z. Do you mean that the tranny mount and the drive shaft from the automatic tranny fit the manula tranny? Or do you mean that you swapped in a new driveline and mount with the manual? I just want to clarify to be extra sure. Thanks again!

A 99% is much better than what I had before! Thanks! I am getting the flywheel, clutch, pedal, master cylinder and the tubing with it. (just need to get the slave) So, thanks again! P.S. If anyone knows that this is wrong, please let me know. Otherwise I will take this as "your final answer."

I do need to find out. I am getting the 240Z this weekend from someone who has a 4-speed that they are throwing in too. But I want to know a head of time if I need to be looking for a new driveshaft. Anyone else know?

I've searched, but haven't found much about the automatic transmission. (guess its not that popular!) So, from what I've read, everyone thinks that the driveshaft is the same length for either tranny? If so, I am in luck! If not, I'm in trouble... Thanks for the posts!

About the auto tranny, I don't know. I haven't seen it yet! The manual is from a 1971 240Z that was made about 2 months after the one I am getting. It is the 4 speed. Does that change anything?

I am getting a 1971 240Z with an automatic transmission (it doesn't work, slips too much). I am also getting a manual transmission with it (with flywheel, clutch, pedals, etc). Here are my questions: I know that it will bolt right up to the engine, but what about the driveshafts? Is the length different for the two transmissions? Also, does anyone know where I could get the manual tranny mounts? Last thing, where is the best place to get a slave cylinder for it? Thanks for your help guys!!