Jump to content
Remove Ads

jersey280z

Free Member
  • Joined

  • Last visited

Everything posted by jersey280z

  1. Steve thanks again! Problem solved! I seem to have confused two connectors which caused the issue. Unfortunately, I had tried this before with no positive result. I began to think to myself why am I getting such low voltage, but was still getting some voltage. Well, turns out I was thinking too much like a modern day car and didn't realize the turn signals don't activate unless the car is in the ON position. Once I placed the the key in the ON position, turn signals were back. So for anyone in the future trying to diagnose turn signal issues, key must be in ON position (all the way over before starting, fuel pump engaged).
  2. Thanks for the info!...it appears these wires lead to the old gauge..which is now gone..What would I need to do to bypass the gauge to replicate what the plug use to do?
  3. Hey guys! I own a 1976 280z. My wife overheard me talking about the intellitronix gauges for our vehicles and recently purchased me the tach and speedo. I replaced the speedo cable with an electronic speedo sensor as well. While installing, I cut the white plug connectors off of the original gauge wiring and spliced them into the new gauge wiring. I identified the power, ground and signal wire within each connector. I then plugged them back into my harness. All works fine except my turn signals. It appears that leading from the turn signal portion of the combo switch there is a 2 connectors, one"white" and one "yellowish" connector. The "yellowish" connector has a W/B, W/R and G leading from the switch to the connector. As everyone can imagine, life got it the way and its been some time since I started the project. I can now no longer remember where this connector connects in. It is the only missing puzzle piece to this disaster ive started. Could this be the culprit of my issue? Any ideas would be great. Thank you!\ Additional info: Hazards work, battery new optima, all bulbs/sockets inspected/replaced, lights work, fuses fine, multimeter is only showing 1.5v at the flasher relay. Relay bench tested and works fine.
Remove Ads

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.