Hey guys!
I own a 1976 280z. My wife overheard me talking about the intellitronix gauges for our vehicles and recently purchased me the tach and speedo. I replaced the speedo cable with an electronic speedo sensor as well.
While installing, I cut the white plug connectors off of the original gauge wiring and spliced them into the new gauge wiring. I identified the power, ground and signal wire within each connector. I then plugged them back into my harness. All works fine except my turn signals. It appears that leading from the turn signal portion of the combo switch there is a 2 connectors, one"white" and one "yellowish" connector. The "yellowish" connector has a W/B, W/R and G leading from the switch to the connector. As everyone can imagine, life got it the way and its been some time since I started the project. I can now no longer remember where this connector connects in. It is the only missing puzzle piece to this disaster ive started. Could this be the culprit of my issue? Any ideas would be great. Thank you!\
Additional info: Hazards work, battery new optima, all bulbs/sockets inspected/replaced, lights work, fuses fine, multimeter is only showing 1.5v at the flasher relay. Relay bench tested and works fine.