grnsky

Coil is good, need more wiring write ups for MS2. Installed new clutch slave cylinder, electric radiator fans are too small, Working through the bends.

First attempt to start made today!!! Fuel is good, No Spark however. More investigation needed...

Thanks, I couldn't take the credit for it though. Got some Tokicos for the rear courtesy of Hybridz. Went ahead and installed them today. Still need some filters, clamps, hoses, etc. Maybe tomorrow for start up.

Thanks Euro, made a little more progress today. Heat has been crazy lately. Intercooler was mounted using the horn holes, fuel pump wiring is already in place from stock harness? I have a collection of coils, but is pretty much ready for first start up. (:

Heres some pics from my company's car show. One is better than none, Completely stock.

New radiator installed, changing out exhaust bolts for studs. Progress is slow.

Drive shaft, speedo cable and exhaust down pipe installed today. Start on wiring harness on Sun.

T5 trans install completed today. Mount was fab'd and installed. The Mustang shifter feels terrific. Will take pics. No trans tunnel cutting required. (:

Thanks Chas, LSD was installed today along with Tokicos in the rear. Rear needs a complete refresh, but will have to wait for until after car is running. Aiming for Sept car show in LBC to have the car running.

Yes the whole strut assy. Car came with some great looking MSA sway bars and some other goodies. Had some major success today, eng and T5 installed. Lots and lots of work.

Front end back together (:

Haha, yes I got very lucky with this one. I pulled out the LSD the other day.

Hey Rich, Yes Tokicos all round, hoping to swap out the front struts. Made an effort to clean up the gearbox after work. Much cleaner.

Yes, donor car is very much rust free. Drums on the rear. ):

Thanks Eurodat, Painting is a good feeling. Bought another 280Z donor car. Will be using its brakes, motor and diff.

Painted both sides/ Looking better

The 'refresh' is quickly becoming a restore! Pulled fenders off in order to get the front end done right. Dirt goes everywhere when cleaning out these areas. But will be 10lbs lighter when all put back together.

Suspension work mostly complete.... Weather is getting better for it.

Thanks, Patience is definitely a virtue. The grit/dirt build up is unbelievable. I'm sure Hardway can attest to this. I still have the rear susp to do, but shouldnt be as involved as the front. E-Tek your restos look great.

Cleaned up well, waiting on some bushings, still need to finish up the struts before putting back together. Progress is slow,

40 years of grit.....

When some becomes more.... The whole front end comes off! New shocks, etc. Perfect weather for a couple hrs of work.

Thanks Hardway, Hoping to install some steering components over the weekend. Tie rods, ball joints, steering rack boots, bushings, performance sway bar, etc. Hopefully the weather holds. Replaced the head gasket last week also.

Small progress made today. New steering bushings installed, and a new fuel line. Hoping things progress quicker with the warmer weather.

Thanks esmit, Motor decision made. The work started today after the holiday hiatus.