Search the Community
Showing results for tags 'old school'.
Found 1 result
-
Greetings, I need some good ideas on setting up the suspension of a 71 for endurance road racing. But first a bit of information The Car current condition 71 Z early L28 block (200 dyno HP) 5 speed stage 1 clutch, clutch masters R-180 4:11 open Unknown lowering springs Tokiko illuminas AZ Dave big vented discs WW 1" MC Prop valve New bearings u joints - new bushings (urethane) bump steer spacers short steering arms F 205/50/16 R 225/50/16 Dierzza ZII ST sway bars F&R Stock camber castor new "big dog" frame rails 6 pt roll cage tied in shock towers with cross bay between shock towers. We ran at Sears point 3 days - 24 hours of track time (less pits) car never pushed but we spun a few times - i know i know driver error .. FYI fastest lap 2.09 fasted lap of all cars 2.04 (ok 1 car had a 2:01 on Monday when there were only 60 cars instead of 160.. point is while we are not the best drivers we are competitive.. We would like to get any old school el cheepo racing fix advice for the following needs. - with the lemons caveat (need it to work and not cost a boat load - ie no coilovers, no AZ Z track pack, etc creative ideas rewarded.. Camber - we need negative camber! so far the only idea we are looking at is slotting the top holes at all 4 corners and moving the front holes up and out in the ft cross-member. Any other thoughts? Caster? we got nothing here, any ideas and what will it get us. Lowering. car came with unknown lowering springs looks like about 1 inch. but needs to be lower, lots of room over the tires and car has bump steer spacers... Best so far is advice from Dave Robello, suggested cutting top hats down an inch, (heat up rubber take it out slot metal re install cut down drops car keeps suspension travel... any other ideas. keep in mind aesthetics are no issue so we could section the shock towers and raise them .. lots of work and not sure our quality of work would keep them absolutely centered in original geometry... Tightening up rear.. negative camber will help -0 camber now.. somebody suggester going to 17 inch rims and bigger wider tires.. thoughts staggered set up no problem, clearance no problem (just cut out any offending metal... _ if so how wide we have a nother l28 block we are building and may get to 225 or so HP.. Any ideas are appreciated PS picture is from Sears Point channeling Bob Bondurant - we were of course Bad Bondorot..