Make Datsun

Single Carburettor INTAKE MANIFOLD ONLY to suit listed models

I believe it is off a 240K OR 260C SEDAN

STAMPED Y88

do any of my mates down under know where i can get my hands on one of these manidold's? thanks mike znap01@aol.com

any pics of what your after as i have a few different ones but y88 is not ringing any bells.

thanks for the reply bob the intake came on the datsun laurel in eastern europe here is one i put on my 73 240 z

You won't have much luck with a Y88 variant from Australia but an E30 is doable.

Similar except that the E30 doesn't have the same heating provision.

The ports may be a little smaller also but some rework would sort that.

If the lack of heat source, which is mostly to do with pollution reasons, doesn't matter I can find out what postage to Ga would be for the unloved E30 here.

edit: must change that avatar - the KGT is long gone

thanks guy's went to a holly 390 as the z has a turbo on board mk