
GV Z Car
Members-
Content Count
72 -
Joined
-
Last visited
Community Reputation
5 NeutralAbout GV Z Car
-
Rank
Registered User
Contact
-
Map Location
Garden Valley, CA
-
Occupation
Sales Representative
My Cars
-
Zcars Owned
240z
260z -
About my Cars
HLS30 - 37015<br />
engine running strong after 21 year nap<br />
working on the rust!
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
-
GV Z Car started following Replacement Hard Brake Lines, Brake light (switch?) question, Swapping to f54/p90 and and 2 others
-
Oem motor mount p/n : 11220-N3300
-
As I recall, I ended up finding a set of oem mounts.....aftermarket set did not align up...
-
This is the picture showing bushings already installed. There is a sleeve that fits between the bolt and these bushings. Sent from my [device_name] using http://Classic Zcar Club mobile
-
Thank you for the quick reply. I have a bolt that works and even the bushings that go into the pedal, but am looking for the sleeve that goes over the bolt and through the pedal shaft.1534203818922 Sent from my [device_name] using http://Classic Zcar Club mobile
-
Looking for the following parts or advise from those that have barked up the tree! I have too much free travel in my clutch to allow me to adjust the clutch. The bolt that holds the pedal in place and creates the fulcrum (p/n 46561-21000) and the sleeve that fits over the bolt (p/n 46582-21000) are nla....trying a work around with a bolt I picked up, but it is still not the proper diameter and causes too much free play. Any advice is appreciated. Sent from my [device_name] using http://Classic Zcar Club mobile
-
Bracket for 1972 Electric Fuel Pump Upgrade
GV Z Car replied to JLPurcell's topic in Open Discussions
fyi....The picture that I posted above shows a bracket I pulled from a 1974 260...(that I installed on my 71 240). -
Bracket for 1972 Electric Fuel Pump Upgrade
GV Z Car replied to JLPurcell's topic in Open Discussions
Here ya go.. Sent from my [device_name] using http://Classic Zcar Club mobile -
Here's a pic... Sent from my [device_name] using http://Classic Zcar Club mobile
-
I found they where not exact, but fit well enough to work (I did have to bend in one spot). Sent from my iPad using Classic Zcar Club mobile
-
Yes it does! Sent from my iPad using Classic Zcar Club mobile
-
Here it is installed, with the correct engine mount isolator arms. Sent from my XT1585 using Classic Zcar Club mobile
-
Sent from my XT1585 using Classic Zcar Club mobile
-
Turned out I had the engine mount isolator "arms reversed. Sent from my iPad using Classic Zcar Club mobile
-
Good question. I do not know as I bought it (and the motor) used (but never fired) . I am doubting it....and am wondering if that would even matter ( wouldn't be 180 degrees on the other side....)? Sent from my iPad using Classic Zcar Club mobile
-
Yes I as well not liking that....