Jump to content

IGNORED

Finishing the inside of door (under the door panel)


Recommended Posts

Three questions on this:

I have some leftover Thermo Tec. Has anyone seen any benefit in applying this to the door?

The openings in the door were each covered with homemade plastic covers that I made 20-30 years ago out of 5 mil Mylar, but I don't remember if I was replacing factory-original covers.  Were these original?

The entire door was covered by a 'watershield', but I remember even less about that.  The FSM only mentions that it exists, but doesn't illustrate it.  I think it was a thin plastic sheet secured on the top and sides (but not bottom).  Does that sound right?

Thanks in advance...

Link to post
Share on other sites

Here's a picture of the original vapor barrier on my 7/70 240Z, before I disassembled the door. It was held on with adhesive all the way around the perimeter. I assume 280's were similar.

20191020_101217_HDR.jpg

  • Agree 1
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.