Jump to content
adivin

Half Shaft U Joint

Recommended Posts

Did the original 240Z Nissan U Joints on the half shafts have grease fittings?

Share this post


Link to post
Share on other sites

From memory they did not, though it's been several years since I researched this.  As I recall I replaced mine with Spicer u-joints that do have a grease fitting.

Share this post


Link to post
Share on other sites

I know the later cars had the holes for the Zerks but they were capped with a screw.  Remove the screw, insert the Zerk, fill with grease, reverse procedure.

I don't know about the super early 240Z's though.  But the hexagonal screw head is easy to see if it's not covered in grease and dirt.  It should have slot in it also, for a screwdriver.

Edited by Zed Head

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.