Sailor Bob

Swapping to f54/p90

    Recommended Posts

    4 hours ago, GV Z Car said:

    As I recall, I ended up finding a set of oem mounts.....aftermarket set did not align up...

    Do you have a part number?

    Share this post


    Link to post
    Share on other sites

    I have Westar EM-2401. Anyone know the correct bolt size? The threaded receiver is full of paint dont want to strip the thread and bore.

     

    Share this post


    Link to post
    Share on other sites

    I have the rails but i am using the base pan off the old engine.  They looked kind of ratty. Im guessing i dont need them.

    replacement bolts are all the same length.

     

     

    Edited by Sailor Bob

    Share this post


    Link to post
    Share on other sites

    I think that they reduce the odds of leaks.  Maybe also strengthen the seal for when you bump the bottom of the pan on something.

    Share this post


    Link to post
    Share on other sites

    5 hours ago, Zed Head said:

    I think that they reduce the odds of leaks.  Maybe also strengthen the seal for when you bump the bottom of the pan on something.

    Yeah, you're quoting my conscience. 

    Share this post


    Link to post
    Share on other sites

    That back most header stud was too short on mine too. I bought one from nissan for a v8 titan truck that was enough to bolt it down. 

    I have them on the front and the the rear. M10 so I had to open up the hole a little.

    Edited by siteunseen
    • Like 1

    Share this post


    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now