Help Me !!
This is the emergency HELP ME forum for those of you that are having troubles with your Z-Car and need immediate help.
6,083 topics in this forum
-
- 3 replies
- 853 views
Could anyone tell me if I can switch a dual point dist. for a single point dist. and if I did how much work would be involved. Thanks Rob
Last reply by Z train, -
-
- 10 replies
- 1.7k views
Hey guys. This evening when I was back home and got out of the ol' gal I started smelling a rather potent smell of sulfur (rotten egg type smell). Any ideas? Jan
Last reply by Z train, -
- 2 replies
- 923 views
Well I finally got the carbs synched and running great- the car just died on me! Info on the car: L24 Tripple Weber 45 DCOE - 36mm chockes - 145 mains - 195 air Mallory Unilite/ pro master Electric Fuel Pump FPR set at 3.5 psi ____________________________ I was driving and the car just died. I pulled over and tried cranking it. It turned over and didn't sound like any battery problems. I gassed it and then it would rev up really quickly and then die. I could not get it to idle at all- just rev and then die. I checked the fuel pressure and it read 3-4 psi. I disconnected the hose after the electric fuel pump to make sure fuel was coming out while cranking it and it did jus…
Last reply by Esc8p2NeverLand, -
- 7 replies
- 1.5k views
Hi Z fellows. Help me plz. I need the main bearings caps and oil pump pickup for my L24 block. Anyone knows where can I get them. Thank You.
Last reply by yetterben, -
I'm a new member and new to Z cars. I've recently come into a '73 240z and I'm getting no spark. I've replaced the battery, battery cables, coil, resistor, condenser, plugs, plug wires, distributor cap, rotor, and points. Still nothing. Any suggestions are greatly appreciated.
Last reply by Gary in NJ, -
- 22 replies
- 4.2k views
Hey everyone, over the past few weeks my car has been running progressively worse. I just replaced the spark plugs with new NGK BP6ES plugs and it took away the problems I was having in 1st and 2nd gear (at 5k rpms it would hit almost like a rev limiter, but keep revving sporadically). It was doing this before, but it seems like in 3rd gear or higher it get this violent loss of power and the tach jumps all around. It kind of surges, as if you let off the gas and stomped on it again over and over until you shift or slow down. I think the timing is set around 15 degrees and I am running the pertronix unit and their coil. This isn't something that has been happening for a lo…
Last reply by Cutlass372, -
- 3 replies
- 650 views
Wondering if the early 71's had retracting seat belts or were they more like the 1600/2000 roadsters belts. Thanks....Mark
Last reply by Arne, -
- 5 replies
- 1.7k views
I'm sure this has been asked before but. One of the many rubber lines on the fuel rail has developed a very slow leak on my 280z. (76'). Is there any tricks or hints you guys can give me on replacing them. Is it just basically take out and put in or is there something special I should do. Thank Jan
Last reply by JohnnyO, -
- 4 replies
- 1.1k views
Was doing some work on my car last night - Changed rear brakes + installed a new Steering Wheel. All was fine but now: My little light in the engine bay is stuck on! Yes it worked before and I could click it on and off. But now its just stuck on? Only way for me to turn it off is to unscrew the light. Any ideas? All comments are welcome.
Last reply by 260zCaliCar, -
- 25 replies
- 5k views
Can you help me locate these parts: These are the bolt/nut that hold the transverse link to the body in my 71 240z BOLT (#54436-E4100) NUT (#08912-84410) WASHER (#56114-09400) I need 2 each... they are discontinued by Nissan as far as I can tell. I can provide pictures if you need.... THANK YOU! Mark
Last reply by Terrapin Z, -
- 3 replies
- 860 views
As stated in my previous posts, I am just undertaking the task of rebuilding a 71 240. The rear hatch that I have has a few areas of rust, especially around the lower corners of the glass. I plan to remove the glass and do any repair work possible. Unfortunately, I think it may be beyond repair. I have searched all the classifieds, ebay, MSA, Black Dragon, and local junk yards and have yet to find any rear hatch's. Does anyone out there have any advise as to locating such a part? Any help would be greatly appreciated! Thanks!
Last reply by Triple G'Z, -
- 12 replies
- 1.9k views
Im going to look at a couple 280z's over the next week, and id like to know where i should look to determine if the cars are too far gone due to rust. Keep in mind, i wont have any way to jack these vehicles up into the air. Hopefully i can raise the carpet to check floor boards. I know there are some signature spots within these z's that rust out and are a pain to fix. Unfortunately im new to the z world, so i need advice. Thank you. Scott
Last reply by Scaotty,
-
Recently Browsing 0 members
- No registered users viewing this page.