Jump to content

footballnick17

Members
  • Content count

    82
  • Joined

  • Last visited

Community Reputation

1 Neutral

About footballnick17

  • Rank
    Active Member

Contact

  • Map Location
    Greenfield Park, Quebec

Profile

  • Gender
    Male
  • Occupation
    Student

My Z Cars

  • Zcars Owned
    240z
  1. Valve Adjustment

    Thanks siteunseen I appreciate it Sent from my iPhone using Classic Zcar Club mobile
  2. Valve Adjustment

    Planning on adjusting the valve lash pad with the camshaft, what are the measurements supposed to be when cold? I’m getting a lot of different answers on google. Thanks Sent from my iPhone using Classic Zcar Club mobile
  3. Camshaft kit

    Stock from Datsun, don’t need the head since I got a new one, just trying to sell old parts that I have lying around. Sent from my iPhone using Classic Zcar Club mobile
  4. Camshaft kit

    I have this kit that was on my E88 head but I took it off because the head was scrap. What do kits like these go for? Sent from my iPhone using Classic Zcar Club mobile
  5. Ignition Coil Wiring 1972 240Z

    I will check that out when I work on the Z again, thanks for your help! Sent from my iPhone using Classic Zcar Club mobile
  6. Ignition Coil Wiring 1972 240Z

    I have only had the car for about a year now, I have never seen the tach work since I just got the engine running. How could I see if the tach itself is bad? Sent from my iPhone using Classic Zcar Club mobile
  7. Ignition Coil Wiring 1972 240Z

    Hi, Does anybody have a picture of how their wires are connected on their ignition coil and ballast resistor. I think mine might be connected wrong, the engine runs but the tachometer does not work. Any help would be appreciated. Nick
  8. This is my stacked exhaust

    Yeah it’s two pipes all the way from the manifold. Sent from my iPhone using Classic Zcar Club mobile
  9. This is my stacked exhaust

    No it has the stock L24 engine, came with the car when I got it Sent from my iPhone using Classic Zcar Club mobile
  10. This is my stacked exhaust

    Anyone know anything about it and if it’s a uncommon set up. Sent from my iPhone using Classic Zcar Club mobile
  11. Rear disk brake conversion

    I’m seriously considering a disk brake conversion for my ‘72 240z, what are some good kits that are relatively cheap and what problems will I encounter doing this conversion, thanks. Sent from my iPhone using Classic Zcar Club mobile
  12. Brake wheel cylinders

    Kool thanks Sent from my iPhone using Classic Zcar Club mobile
  13. Brake wheel cylinders

    I have a 1972 Sent from my iPhone using Classic Zcar Club mobile
  14. Brake wheel cylinders

    Any idea on how to remove the brake wheel cylinders, mine need to be replaced and I cannot figure it out. Thanks Sent from my iPhone using Classic Zcar Club mobile
  15. I bought a new master cylinder for the clutch and I am trying to bleed the system but it seems like the master isn’t building up pressure at all. Any advice on bleeding the system I feel like there’s a fair amount of air in the line. Sent from my iPhone using Classic Zcar Club mobile
×