Casey_z Posted January 5, 2015 Share #13 Posted January 5, 2015 Finally installed Z's onthe brain head light upgrade. If it wasn't for a PO's butchering of the headlight hookup on the right side it would have been painless. Great upgrade. I had it sitting ready a while but naturally I waited till I also had to take the headlight switch off due to overheating and cleanup and repair it also.http://www.kamikazeracing.org/dl/ZTe...mbo_switch.pdf Great link if you are a little handy. Middle pic is the connector some one used instead of proper one. Buddy of mine in the Ontario z car club gave me proper connectors and a little time with a meter test light and wiring diagram made it happen. With a Bosch H4 headlight upgrade that was already installed I will have to use my lowbeams Still am going to cleanup the harness in front of the rad. I have all winter 1 Link to comment Share on other sites More sharing options...
Oiluj Posted January 5, 2015 Share #14 Posted January 5, 2015 Casey_ZYou will find the headlight relay makes a huge difference, especially in conjunction with halogen headlights! Link to comment Share on other sites More sharing options...
anthony_c Posted January 7, 2015 Share #15 Posted January 7, 2015 second round of rings, bearings, seals, gaskets, oil pump, and timing setrepeat the valve jobrefresh the su'slog a few break-in milesand order a new brake booster wheeee! Link to comment Share on other sites More sharing options...
Casey_z Posted January 8, 2015 Share #16 Posted January 8, 2015 Cleaned up the harness a bit Good thing I have heat in the garage. It is below zero outside Casey Link to comment Share on other sites More sharing options...
gwri8 Posted January 8, 2015 Share #17 Posted January 8, 2015 Took the Z to Costco and almost forgot what I was driving. Link to comment Share on other sites More sharing options...
siteunseen Posted January 10, 2015 Share #18 Posted January 10, 2015 Got a late Christmas present put on today. Link to comment Share on other sites More sharing options...
240260280z Posted January 11, 2015 Share #19 Posted January 11, 2015 Got a lathe Interesting carb mods in the future. 1 Link to comment Share on other sites More sharing options...
Travel'n Man Posted January 12, 2015 Share #20 Posted January 12, 2015 De-installed my oil temp sending gauge from my oil pan boltInstalled my Mishimoto Sandwich Plate to the block to get a better oil temp reading Link to comment Share on other sites More sharing options...
moelk Posted January 12, 2015 Share #21 Posted January 12, 2015 Got some work done on my f/g doorpanels Link to comment Share on other sites More sharing options...
RED71Z Posted January 13, 2015 Share #22 Posted January 13, 2015 I picked it up from the shop today and drove the $^!# out of it. 1 Link to comment Share on other sites More sharing options...
Diseazd Posted January 13, 2015 Share #23 Posted January 13, 2015 Jasper......Good deer hunting if I recall. Nice looking car. Link to comment Share on other sites More sharing options...
240tom Posted January 13, 2015 Share #24 Posted January 13, 2015 I pulled all four of my five slot mags and took them to my friendly neighborhood shine master. Will post pix when they are back. Link to comment Share on other sites More sharing options...
Recommended Posts