beandip
09-28-2003, 03:14 PM
I finely started to reassemble the ol' blister . One thing I want to pass on , I was using the mariene clean on the inner fender , I have the fenders removed. there is a pannel that is just infront of the door that makes a chamber that the water draines from cowel . On the driver's side the pannel leaves a 1/4"
gap that allowed water and debris to enter from the wheel area. There is also a large drain that dumps the water from the cowel into the cavity of the fender in front of the door , this is an area that debris collect and hold water , this area is seen as a rust prone area and is the front of t he rocker pannel. I am installing a 45deg pvc pipe fitting and a section of large vynal tubing from home base , to run from the cowel drain down to the bottom of the cavity and drain . This is to clear the water and debris from the cowl area. :classic:
gap that allowed water and debris to enter from the wheel area. There is also a large drain that dumps the water from the cowel into the cavity of the fender in front of the door , this is an area that debris collect and hold water , this area is seen as a rust prone area and is the front of t he rocker pannel. I am installing a 45deg pvc pipe fitting and a section of large vynal tubing from home base , to run from the cowel drain down to the bottom of the cavity and drain . This is to clear the water and debris from the cowl area. :classic: