Is it possible

[Chrisdyson]

Hey guys does anyone know if its possible to put a vq35de (350z) motor and gearbox in a 240k gt/ c110 skyline coupe any help will be much appricated

[WingZr0]

Think it's been done in a 240Z,
Not to sure about 240K's or C110's though :ermm:

[red_dog007]

Also, I have heard that it is a tight fit for that motor, and even tighter for the V8 VK45 but possible.
Should fit, but a lot of work might be involved.

[sblake01]

Anything is possible. All it takes is money.

[schwiplarkin]

it would take some fabricating, but there is plenty of room.

[240kconvertible]

Anything is possible. All it takes is money.

I can verify this as I now have an old school chrysler 318 (soon to be stroked out to 390 cubic inches) in my coupe and I can change spark plugs without removing the whole engine. As stated all it takes is money.

On mine the line of where the bellhousing meets the engine is 15mm from the firewall. The transmission tunnel in my coupe was hacked up a little though so the engine sits right back for weight distribution.