- 5 speed conversion from auto
- Manual tranny bellhousing bolt length?
- Strut Cartridge Removal
- Rear Suspension Rebuild
- Rack & Pinion Inspection and Boot Replacement
- Common problem #487 - shifter hitting console! (long)
- 3-Car Comparison
- Shortening Struts
- Leaky Rear Main Seal
- Tokico Illumina 5-way Shocks
- Replacing suspension bushings
- Strut Cartridge Replacement - Dampening Oil
- differential question
- Gearbox pops out of 5th.
- Speedo Question
- technique for replacing mustache bar bushings
- '81 5-spped into a '73 240Z
- Steering wheel replacement
- 5 Speed Truck Transmission
- auto to 4spd swap in 73'
- Rack -and- Pinion?
- Correct Z tire size
- rumble from my rear end (forgive the description)
- Noise in the differential
- Help with wheel fitment (offset, sizes, etc.)
- Suggestions for front end shimmy situation
- coil over feel
- Ideas from the Z Gurus of the world.
- 15" VS 16" rims on the 240
- Clutch plates differences?
- strut inserts dimensions
- Yellow Springs- Who makes them?
- performance shocks
- swap rims
- Rumble noise in the back end
- Rear Diff upgrade
- Vg 30
- 240z to 280z? tranny swap
- Auto to Manual
- Light Flywheel Performance
- Rear Diff...................
- curved shifter help.
- shaved/lightened flywheel?
- RACK AND PINION Compatibility
- How good is a stock 240 suspension?
- help me get my cases apart...
- transmission rebuild kits/sources
- any r-180's with 3.9 gears
- "GUNK" motor flush experience...
- "red line" oil?
- Non-modification camber kits (MSA)
- Manual Trans Oil?
- R-200 LSD Rebuild
- Strut bar????
- Intake Manifold-Triple Webbers
- Wheel Puller
- There are no stupid questions...
- My rear end sqeeks!
- What shocks and springs to get?
- vibration coming from wheel
- 3.15 diff???
- 240 Bolt Pattern
- Best Wheel / Tire Combo?
- Eibach progressive springs explanation?
- What Is The Stock 240 Ride Height?
- 4-Speed to 5-Speed Conversion
- Wheel Stud Removal?
- Nissan Motorsports Euro Spring part numbers
- Heavy Steering Effort 280Z ???
- Help! Why is the 240Z this way?
- Tires for 77 280Z??
- Springs and Shocks
- Shifter slop fix.
- Steering shaky?
- Tire Survey
- 4 spd vs 5 spd
- Replacement of shifter bushings
- Swapped Ring&Pinion - Speedo needs adjusting
- Nissan Comp LSD vs Quaife
- Rear control arm bushing replacement
- Tire dimensiosn 14 inches please!!!
- Front End Shakes
- Front Hub and Rear Control arm compatibility
- shifter knob
- installing rear shoes
- sloppy shifter
- brake pads, old ones glued in?
- rear diff oil?
- Bumpy ride
- coil-overs or no?
- Bushings at the MSA show...
- shortened steering knuckles
- Which cars have the R-200 differential?
- posi traction on 72' 240z?
- High Performance Suspension
- formula 1 z
- Brake Hiss (Help please)
- Shimming R180 LSD diff
- Lost my clutch!
- switching differentials......
- Spring Perch help!
- how much does a good set of lowering springs cost?
- do you think 4-11's are too low?
- I need alignment advice
- Mastervac actuator rod grease?
- Coil Overs?
- Where is Rear drum-to-disc conversion?
- 'Stock' 15's that fit Z???
- spherical bearing TC rods from MSA show...
- Funny sounds from up front
- TC rod aftermarket bushing kit question
- Skinny vs. Fat....
- Dunlop Sport A2
- Nissan comp lsd driveshaft compatibility???
- Spring rates
- what is my final gearing?
- Strut question
- Switching wheels???
- 16.75:10 R-180
- Toyo Proxes TPT
- ZX rear disks are SOOO wimpy!
- ultimate front strut bar
- 4 Wheel Alignment Settings
- Strut Bar Plans / Specs
- Clunk in diff, not mustache or u-joints
- Clutch problems
- steering wheel shakes....
- Rebuilding Z calipers
- Transmission Bearing
- Tip: Brake System Maintenance
- New tires for my ZED!!!!
- Shift Linkage Question???
- Tets
- Rear Strut Removal
- pivot pin removal -tranverse link
- Can steering u-joint be replaced?
- vibration at speed
- Help!!!
- Fuel Pump
- KYB vs GABRIEL
- Suspension rebuild
- mustache bar mounting pins
- What size sway bars
- Jag rearend
- Removal of #@$%ing rear pins & bushings.
- front-end camber ?'s
- R180 Lsd
- Rear Bearings
- brake master cylinder advice
- Uni body rusted, saved my z from junkyard
- What do r200 3.90's go for?
- Poly-suspension complete - Where to buy?
- Hey all you aussie guys
- ring and pinion
- 4-piston brake conversion questions
- Rear Sway Bar
- Frame Rail Rust
- Clutch Replacement, how hard, and how long?
- Brake Conversion Problems, Need metal line!
- Short Shifter
- 5 Speed Choices - Advice Needed
- out of the hole
- brake pedal pumping required
- T/C rod servicing
- How hard is it to fix a broken emergency brake?
- Moustache bar
- R200 R180 Rear End Slack, How much seems normal
- camber,castor,tow and ride height
- Rear end thunk
- Upgraded brakes
- 200 SX Turbo R200 Rear end and Zx caliper conversion.
- cartriges
- strut dust boots and bump steer spacers
- solid differential mount
- UK Insurance
- Drive Pinion (diff) Slackness
- Help with my Clunk and Grind
- Front end vibration at all speeds
- Urethane Control Arm Bushings Install
- Front Control Arm Bushes.
- Handbrake Adjustment
- the legal kind of lsd.
- Ball joint prices?
- Hub bearings & front end vibration
- Front sway bar issues
- R180 & R200 diff covers
- I want to put a 4speed auto in the 240 help
- Front Control Arm Bush Question.
- '73 auto trans to a Maxama 4speed auto what is involved
- Gas suspension
- Differential ratio on an automatic trans
- Right Front Shakes
- Spring sizes
- '79 vs '82 rear disc calipers - opinions?
- 83 280ZX Clutch, cable or hydraulic?
- Ok, Now I'm MAD
- Rear Coil-over/Drag Launch setup?
- U-Joint problem????
- U-Joint problem????
- Steering tracking problems
- shoccks and springs
- Road Racer alignment specs?
- bushing
- difference in rear ends?
- Clutch Qusetion about Borg-Warner T-5?
- Power Steering?
- Arizona Z Car cro-moly control arms??
- rear suspension
- diff crossmember
- Mustache bar bushing screw up. help?!
- Mustache bar bushing bushwacked!
- Negative Camber
- How to replace front rack bushings??????
- Shortened strut compatability
- Why do my brakes squweeeeel?
- Eibach springs
- Tranny won't go back in?!?
- rear end noises
- The name of the tool to adjust coilovers
- Gland nut removal...
- Starter
- r180 diff bearing problem
- Wish Me Luck
- Gear Shift Lever Boot
- Differential?
- Howling Differential
- Coil spring perch distance question
- Bushing Kits..
- Suspension: 240 vs 260
- to align or not align
- Wheel Bearing Part Numbers
- Front coil springs
- front strut
- Cause of early Internal VR alternator failure
- Which Shocks? and Where From?
- Lowering Suspension
- Powersterring leak!
- Tranny swap.
- Suspension Gurus HELP!!
- p90/A ?
- Wanted: 240 inicator assembly
- Ball joint -- good or bad?
- ball joint brand
- Urethane or Rubber bushings
- Phantom Grip
- Rebuild kit for the powersteering?
- KYB Gland nuts
- r200 limmited slip
- Q. 1.) Removing lower control arm...
- Removing 5-speed from 240